Center for Biofilm Engineering (CBE)
Permanent URI for this communityhttps://scholarworks.montana.edu/handle/1/9334
At the Center for Biofilm Engineering (CBE), multidisciplinary research teams develop beneficial uses for microbial biofilms and find solutions to industrially relevant biofilm problems. The CBE was established at Montana State University, Bozeman, in 1990 as a National Science Foundation Engineering Research Center. As part of the MSU College of Engineering, the CBE gives students a chance to get a head start on their careers by working on research teams led by world-recognized leaders in the biofilm field.
Browse
8 results
Search Results
Item Addressing wellbore integrity and thief zone permeability using microbially-induced calcium carbonate precipitation (MICP): A field demonstration(Elsevier BV, 2020-02) Kirkland, Catherine M.; Thane, Abby; Hiebert, Randy; Hyatt, Robert; Kirksey, Jim; Cunningham, Alfred B.; Gerlach, Robin; Spangler, Lee; Philips, Adrienne J.Microbially-induced calcium carbonate precipitation (MICP) is an emerging biotechnology for wellbore integrity applications including sealing defects in wellbore cement and modifying the permeability of rock formations. The goal of this field demonstration was to characterize a failed waterflood injection well and provide proof of principle that MICP can reduce permeability in the presence of oil using conventional oilfield fluid delivery methods. We compared well logs performed at the time the well was drilled with ultrasonic logs, sonic cement evaluation, and temperature logs conducted after the well failed. Analysis of these logs suggested that, rather than entering the target waterflood formation, injectate was traveling through defects in the well cement to a higher permeability sandstone layer above the target formation. Sporosarcina pasteurii cultures and urea-calcium media were delivered 2290 ft (698 m) below ground surface using a 3.75 gal (14.2 L) slickline dump bailer to promote mineralization in the undesired flow paths. By Day 6 and after 25 inoculum and 49 calcium media injections, the injectivity [gpm/psi] had decreased by approximately 70%. This demonstration shows that 1) common well logs can be used to identify scenarios where MICP can be employed to reduce system permeability, remediate leakage pathways, and improve waterflood efficiency, and 2) MICP can occur in the presence of hydrocarbons.Item Heterogeneous diffusion in aerobic granular sludge(Wiley, 2020-08) van den Berg, Lenno; Kirkland, Catherine M.; Seymour, Joseph D.; Codd, Sarah L.; Van Loosdrecht, Mark C. M.; de Kreuk, Merle K.Aerobic granular sludge (AGS) technology allows simultaneous nitrogen, phosphorus, and carbon removal in compact wastewater treatment processes. To operate, design, and model AGS reactors, it is essential to properly understand the diffusive transport within the granules. In this study, diffusive mass transfer within full‐scale and lab‐scale AGS was characterized with nuclear magnetic resonance (NMR) methods. Self‐diffusion coefficients of water inside the granules were determined with pulsed‐field gradient NMR, while the granule structure was visualized with NMR imaging. A reaction‐diffusion granule‐scale model was set up to evaluate the impact of heterogeneous diffusion on granule performance. The self‐diffusion coefficient of water in AGS was ∼70% of the self‐diffusion coefficient of free water. There was no significant difference between self‐diffusion in AGS from full‐scale treatment plants and from lab‐scale reactors. The results of the model showed that diffusional heterogeneity did not lead to a major change of flux into the granule (<1%). This study shows that differences between granular sludges and heterogeneity within granules have little impact on the kinetic properties of AGS. Thus, a relatively simple approach is sufficient to describe mass transport by diffusion into the granules.Item Low-Field Borehole NMR Applications in the Near-Surface Environment(2018-01) Kirkland, Catherine M.; Codd, Sarah L.The inherent heterogeneity of the near subsurface (<200 m below the ground surface) presents challenges for agricultural water management, hydrogeologic characterization, and engineering, among other fields. Borehole nuclear magnetic resonance (NMR) has the potential not only to describe this heterogeneity in space nondestructively but also to monitor physical and chemical changes in the subsurface with time. Nuclear magnetic resonance is sensitive to parameters of interest like porosity and permeability, saturation, fluid viscosity, and formation mineralogy. Borehole NMR tools have been used to measure soil moisture in model soils, and recent advances in lowfield borehole NMR instrumentation allow estimation of hydraulic properties of unconsolidated aquifers. We also demonstrate the potential for low-field borehole NMR tools to monitor field-relevant biogeochemical processes like biofilm accumulation and microbially induced calcite precipitation at laboratory and field scales. Finally, we address some remaining challenges and areas of future research, as well as other possible applications where borehole. NMR could provide valuable complementary data.Item NMR investigation of water diffusion in different biofilm structures(2017-09) Herrling, M. P.; Weisbrodt, Jessica; Kirkland, Catherine M.; Williamson, Nathan H.; Lackner, S.; Codd, Sarah L.; Seymour, Joseph D.; Guthausen, G.; Horn, H.Mass transfer in biofilms is determined by diffusion. Different mostly invasive approaches have been used to measure diffusion coefficients in biofilms, however, data on heterogeneous biomass under realistic conditions is still missing. To non-invasively elucidate fluid–structure interactions in complex multispecies biofilms pulsed field gradient-nuclear magnetic resonance (PFG-NMR) was applied to measure the water diffusion in five different types of biomass aggregates: one type of sludge flocs, two types of biofilm, and two types of granules. Data analysis is an important issue when measuring heterogeneous systems and is shown to significantly influence the interpretation and understanding of water diffusion. With respect to numerical reproducibility and physico-chemical interpretation, different data processing methods were explored: (bi)-exponential data analysis and the Γ distribution model. Furthermore, the diffusion coefficient distribution in relation to relaxation was studied by D-T2 maps obtained by 2D inverse Laplace transform (2D ILT). The results show that the effective diffusion coefficients for all biofilm samples ranged from 0.36 to 0.96 relative to that of water. NMR diffusion was linked to biofilm structure (e.g., biomass density, organic and inorganic matter) as observed by magnetic resonance imaging and to traditional biofilm parameters: diffusion was most restricted in granules with compact structures, and fast diffusion was found in heterotrophic biofilms with fluffy structures. The effective diffusion coefficients in the biomass were found to be broadly distributed because of internal biomass heterogeneities, such as gas bubbles, precipitates, and locally changing biofilm densities. Thus, estimations based on biofilm bulk properties in multispecies systems can be overestimated and mean diffusion coefficients might not be sufficiently informative to describe mass transport in biofilms and the near bulk.Item Detecting Microbially Induced Calcite Precipitation in a Model Well-Bore Using Downhole Low-Field NMR(2017-02) Kirkland, Catherine M.; Zanetti, Sam; Grunewald, Elliot; Walsh, David O.; Codd, Sarah L.; Phillips, Adrienne J.Microbially induced calcite precipitation (MICP) has been widely researched recently due to its relevance for subsurface engineering applications including sealing leakage pathways and permeability modification. These applications of MICP are inherently difficult to monitor nondestructively in time and space. Nuclear magnetic resonance (NMR) can characterize the pore size distributions, porosity, and permeability of subsurface formations. This investigation used a low-field NMR well-logging probe to monitor MICP in a sand-filled bioreactor, measuring NMR signal amplitude and T2 relaxation over an 8 day experimental period. Following inoculation with the ureolytic bacteria, Sporosarcina pasteurii, and pulsed injections of urea and calcium substrate, the NMR measured water content in the reactor decreased to 76% of its initial value. T2 relaxation distributions bifurcated from a single mode centered about approximately 650 ms into a fast decaying population (T2 less than 10 ms) and a larger population with T2 greater than 1000 ms. The combination of changes in pore volume and surface minerology accounts for the changes in the T2 distributions. Destructive sampling confirmed final porosity was approximately 88% of the original value. These results indicate the low-field NMR well-logging probe is sensitive to the physical and chemical changes caused by MICP in a laboratory bioreactor.Item In situ detection of subsurface biofilm using low-field NMR: A field study(2015-09) Kirkland, Catherine M.; Herrling, M. P.; Hiebert, Dwight Randall; Bender, A. T.; Grunewald, Elliot; Walsh, David O.; Codd, Sarah L.Subsurface biofilms are central to bioremediation of chemical contaminants in soil and groundwater whereby micro-organisms degrade or sequester environmental pollutants like nitrate, hydrocarbons, chlorinated solvents and heavy metals. Current methods to monitor subsurface biofilm growth in situ are indirect. Previous laboratory research conducted at MSU has indicated that low-field nuclear magnetic resonance (NMR) is sensitive to biofilm growth in porous media, where biofilm contributes a polymer gel-like phase and enhances T2 relaxation. Here we show that a small diameter NMR well logging tool can detect biofilm accumulation in the subsurface using the change in T2 relaxation behavior over time. T2 relaxation distributions were measured over an 18 day experimental period by two NMR probes, operating at approximately 275 kHz and 400 kHz, installed in 10.2 cm wells in an engineered field testing site. The mean log T2 relaxation times were reduced by 62% and 43%, respectively, while biofilm was cultivated in the soil surrounding each well. Biofilm growth was confirmed by bleaching and flushing the wells and observing the NMR signal’s return to baseline. This result provides a direct and noninvasive method to spatiotemporally monitor biofilm accumulation in the subsurface.Item Biofilm detection in a model well-bore environment using low-field magnetic resonance(2015-09) Kirkland, Catherine M.; Hiebert, Dwight Randall; Phillips, Adrienne J.; Grunewald, Elliot; Walsh, David O.; Seymour, Joseph D.; Codd, Sarah L.This research addresses the challenges of the lack of non-invasive methods and poor spatiotemporal resolution associated with monitoring biogeochemical activity central to bioremediation of subsurface contaminants. Remediation efforts often include growth of biofilm to contain or degrade chemical contaminants, such as nitrates, hydrocarbons, heavy metals, and some chlorinated solvents. Previous research indicates that nuclear magnetic resonance (NMR) is sensitive to the biogeochemical processes of biofilm accumulation. The current research focuses on developing methods to use low-cost NMR technology to support in situ monitoring of biofilm growth and geochemical remediation processes in the subsurface. Biofilm was grown in a lab-scale radial flow bioreactor designed to model the near wellbore subsurface environment. The Vista Clara Javelin NMR logging device, a slim down-the-borehole probe, collected NMR measurements over the course of eight days while biofilm was cultivated in the sand-packed reactor. Measured NMR mean log T2 relaxation times decreased from approximately 710 to 389 ms, indicating that the pore environment and bulk fluid properties were changing due to biofilm growth. Destructive sampling employing drop plate microbial population analysis and scanning electron and stereoscopic microscopy confirmed biofilm formation. Our findings demonstrate that the NMR logging tool can detect small to moderate changes in T2 distribution associated with environmentally relevant quantities of biofilm in quartz sand.Item Simultaneous Gaussian and exponential inversion for improved analysis of shales by NMR relaxometry(2015-01) Washburn, K. E.; Anderssen, E.; Vogt, Sarah J.; Seymour, Joseph D.; Birdwell, J. E.; Kirkland, Catherine M.; Codd, Sarah L.Nuclear magnetic resonance (NMR) relaxometry is commonly used to provide lithology-independent porosity and pore-size estimates for petroleum resource evaluation based on fluid-phase signals. However in shales, substantial hydrogen content is associated with solid and fluid signals and both may be detected. Depending on the motional regime, the signal from the solids may be best described using either exponential or Gaussian decay functions. When the inverse Laplace transform, the standard method for analysis of NMR relaxometry results, is applied to data containing Gaussian decays, this can lead to physically unrealistic responses such as signal or porosity overcall and relaxation times that are too short to be determined using the applied instrument settings. We apply a new simultaneous Gaussian-Exponential (SGE) inversion method to simulated data and measured results obtained on a variety of oil shale samples. The SGE inversion produces more physically realistic results than the inverse Laplace transform and displays more consistent relaxation behavior at high magnetic field strengths. Residuals for the SGE inversion are consistently lower than for the inverse Laplace method and signal overcall at short T2 times is mitigated. Beyond geological samples, the method can also be applied in other fields where the sample relaxation consists of both Gaussian and exponential decays, for example in material, medical and food sciences.