Scholarly Work - Mechanical & Industrial Engineering
Permanent URI for this collectionhttps://scholarworks.montana.edu/handle/1/8878
Browse
7 results
Search Results
Item Germ‐Free C57BL/6 Mice Have Increased Bone Mass and Altered Matrix Properties but Not Decreased Bone Fracture Resistance(Wiley, 2023-08) Vahidi, Ghazal; Moody, Maya; Welhave, Hope D.; Davidson, Leah; Rezaee, Taraneh; Behzad, Ramina; Karim, Lamya; Roggenbeck, Barbara A.; Walk, Seth T.; Martin, Stephen A.; June, Ronald K.; Heveran, Chelsea M.The gut microbiome impacts bone mass, which implies a disruption to bone homeostasis. However, it is not yet clear how the gut microbiome affects the regulation of bone mass and bone quality. We hypothesized that germ-free (GF) mice have increased bone mass and decreased bone toughness compared with conventionally housed mice. We tested this hypothesis using adult (20- to 21-week-old) C57BL/6J GF and conventionally raised female and male mice (n = 6–10/group). Trabecular microarchitecture and cortical geometry were measured from micro–CT of the femur distal metaphysis and cortical midshaft. Whole-femur strength and estimated material properties were measured using three-point bending and notched fracture toughness. Bone matrix properties were measured for the cortical femur by quantitative back-scattered electron imaging and nanoindentation, and, for the humerus, by Raman spectroscopy and fluorescent advanced glycation end product (fAGE) assay. Shifts in cortical tissue metabolism were measured from the contralateral humerus. GF mice had reduced bone resorption, increased trabecular bone microarchitecture, increased tissue strength and decreased whole-bone strength that was not explained by differences in bone size, increased tissue mineralization and fAGEs, and altered collagen structure that did not decrease fracture toughness. We observed several sex differences in GF mice, most notably for bone tissue metabolism. Male GF mice had a greater signature of amino acid metabolism, and female GF mice had a greater signature of lipid metabolism, exceeding the metabolic sex differences of the conventional mice. Together, these data demonstrate that the GF state in C57BL/6J mice alters bone mass and matrix properties but does not decrease bone fracture resistance. © 2023 The Authors. Journal of Bone and Mineral Research published by Wiley Periodicals LLC on behalf of American Society for Bone and Mineral Research (ASBMR).Item Subchondral bone structure and synovial fluid metabolism are altered in injured and contralateral limbs 7 days after non-invasive joint injury in skeletally-mature C57BL/6 mice(Elsevier BV, 2022-12) Hislop, B. D.; Devine, C.; June, R. K.; Heveran, Chelsea M.Objective. Post-traumatic osteoarthritis (PTOA) commonly develops after ACL injury, but early changes to the joint soon after injury are insufficiently understood. The objectives of this study were (1) evaluate the response of subchondral bone tissue modulus to joint injury and (2) identify which bone structural, material, and metabolic outcomes are local (i.e., injured joint only) or systemic (i.e., injured and contralateral-to-injured). Design. Female C57Bl∖6N mice (19 weeks at injury) underwent tibial compression overload to simulate ACL injury (n = 8) or a small pre-load (n = 8). Synovial fluid was harvested at euthanasia 7 days later for metabolomic profiling. Bone outcomes included epiphyseal and SCB microarchitecture, SCB nanoindentation modulus, SCB formation rate, and osteoclast number density. Results. Injury decreased epiphyseal bone volume fraction ([-5.29, −1.38%], P = 0.0016) and decreased SCB thickness for injured vs sham-injured limbs ([2.2, 31.4 μm], P = 0.017)). Epiphyseal bone loss commonly occurred for contralateral-to-injured limbs. There was not sufficient evidence to conclude that SCB modulus changes with injury. Metabolomic analyses revealed dysregulated synovial fluid metabolism with joint injury but that many metabolic pathways are shared between injured and contralateral-to-injured limbs.Conclusion. This study demonstrates rapid changes to bone structure and synovial fluid metabolism after injury with the potential for influencing the progression to PTOA. These changes are often evidenced in the contralateral-to-injured limb, indicating that systemic musculoskeletal responses to joint injury should not be overlooked.Item Carpenter bee thorax vibration and force generation inform pollen release mechanisms during floral buzzing(Springer Science and Business Media LLC, 2022-08) Jankauski, Mark; Casey, Cailin; Heveran, Chelsea M.; Busby, M. Kathryn; Buchmann, StephenApproximately 10% of flowering plant species conceal their pollen within tube-like poricidal anthers. Bees extract pollen from poricidal anthers via floral buzzing, a behavior during which they apply cyclic forces by biting the anther and rapidly contracting their flight muscles. The success of pollen extraction during floral buzzing relies on the direction and magnitude of the forces applied by the bees, yet these forces and forcing directions have not been previously quantified. In this work, we developed an experiment to simultaneously measure the directional forces and thorax kinematics produced by carpenter bees (Xylocopa californica) during defensive buzzing, a behavior regulated by similar physiological mechanisms as floral buzzing. We found that the buzzing frequencies averaged about 130 Hz and were highly variable within individuals. Force amplitudes were on average 170 mN, but at times reached nearly 500 mN. These forces were 30–80 times greater than the weight of the bees tested. The two largest forces occurred within a plane formed by the bees’ flight muscles. Force amplitudes were moderately correlated with thorax displacement, velocity and acceleration amplitudes but only weakly correlated with buzzing frequency. Linear models developed through this work provide a mechanism to estimate forces produced during non-flight behaviors based on thorax kinematic measurements in carpenter bees. Based on the buzzing frequencies, individual bee’s capacity to vary buzz frequency and predominant forcing directions, we hypothesize that carpenter bees leverage vibration amplification to increase the deformation of poricidal anthers, and hence the amount of pollen ejected.Item Carpenter bee thorax vibration and force generation inform pollen release mechanisms during floral buzzing(Springer Nature, 2022-08) Jankausk, Mark; Casey, Cailin; Heveran, Chelsea M.; Busby, M. Kathryn; Buchmann, StephenApproximately 10% of flowering plant species conceal their pollen within tube-like poricidal anthers. Bees extract pollen from poricidal anthers via floral buzzing, a behavior during which they apply cyclic forces by biting the anther and rapidly contracting their flight muscles. The success of pollen extraction during floral buzzing relies on the direction and magnitude of the forces applied by the bees, yet these forces and forcing directions have not been previously quantified. In this work, we developed an experiment to simultaneously measure the directional forces and thorax kinematics produced by carpenter bees (Xylocopa californica) during defensive buzzing, a behavior regulated by similar physiological mechanisms as floral buzzing. We found that the buzzing frequencies averaged about 130 Hz and were highly variable within individuals. Force amplitudes were on average 170 mN, but at times reached nearly 500 mN. These forces were 30–80 times greater than the weight of the bees tested. The two largest forces occurred within a plane formed by the bees’ flight muscles. Force amplitudes were moderately correlated with thorax displacement, velocity and acceleration amplitudes but only weakly correlated with buzzing frequency. Linear models developed through this work provide a mechanism to estimate forces produced during non-flight behaviors based on thorax kinematic measurements in carpenter bees. Based on the buzzing frequencies, individual bee’s capacity to vary buzz frequency and predominant forcing directions, we hypothesize that carpenter bees leverage vibration amplification to increase the deformation of poricidal anthers, and hence the amount of pollen ejected.Item Subchondral bone structure and synovial fluid metabolism are altered in injured and contralateral limbs 7 days after non-invasive joint injury in skeletally-mature C57BL/6 mice(Elsevier BV, 2022-12) Hislop, B.D.; Devine, C.; June, R.K.; Heveran, Chelsea M.Objective: Post-traumatic osteoarthritis (PTOA) commonly develops after ACL injury, but early changes to the joint soon after injury are insufficiently understood. The objectives of this study were (1) evaluate the response of subchondral bone tissue modulus to joint injury and (2) identify which bone structural, material, and metabolic outcomes are local (i.e., injured joint only) or systemic (i.e., injured and contralateral-to-injured). Design: Female C57Bl\6N mice (19 weeks at injury) underwent tibial compression overload to simulate ACL injury (n ¼ 8) or a small pre-load (n ¼ 8). Synovial fluid was harvested at euthanasia 7 days later for metabolomic profiling. Bone outcomes included epiphyseal and SCB microarchitecture, SCB nano- indentation modulus, SCB formation rate, and osteoclast number density. Results: Injury decreased epiphyseal bone volume fraction ([-5.29, 1.38%], P ¼ 0.0016) and decreased SCB thickness for injured vs sham-injured limbs ([2.2, 31.4 mm], P ¼ 0.017)). Epiphyseal bone loss commonly occurred for contralateral-to-injured limbs. There was not sufficient evidence to conclude that SCB modulus changes with injury. Metabolomic analyses revealed dysregulated synovial fluid metabolism with joint injury but that many metabolic pathways are shared between injured and contralateral-to-injured limbs. Conclusion: This study demonstrates rapid changes to bone structure and synovial fluid metabolism after injury with the potential for influencing the progression to PTOA. These changes are often evidenced in the contralateral-to-injured limb, indicating that systemic musculoskeletal responses to joint injury should not be overlooked.Item Lacunar-canalicular bone remodeling: Impacts on bone quality and tools for assessment(2021-02) Vahidi, Ghazal; Rux, Caleb; Sherk, Vanessa D.; Heveran, Chelsea M.Osteocytes can resorb as well as replace bone adjacent to the expansive lacunar-canalicular system (LCS). Suppressed LCS remodeling decreases bone fracture toughness, but it is unclear how altered LCS remodeling impacts bone quality. The first goal of this review is to assess how LCS remodeling impacts LCS morphology as well as the composition and mechanical properties of surrounding bone tissue. The second goal is to compare tools available for the assessment of bone quality at length-scales that are physiologically-relevant to LCS remodeling. We find that changes to LCS morphology occur in response to a variety of physiological conditions and diseases and can be classified in two general phenotypes. In the ‘aging phenotype’, seen in aging and in some disuse models, the LCS is truncated and osteocytes apoptosis is increased. In the ‘osteocytic osteolysis’ phenotype, which is adaptive in some physiological settings and possibly maladaptive in others, the LCS enlarges and osteocytes generally maintain viability. Bone composition and mechanical properties vary near the osteocyte and change with at least some conditions that alter LCS morphology. However, few studies have evaluated bone composition and mechanical properties close to the LCS and so the impacts of LCS remodeling phenotypes on bone tissue quality are still undetermined. We summarize the current understanding of how LCS remodeling impacts LCS morphology, tissue-scale bone composition and mechanical properties, and whole-bone material properties. Tools are compared for assessing tissue-scale bone properties, as well as the resolution, advantages, and limitations of these techniques.Item Biomineralization of Plastic Waste to Improve the Strength of Plastic-Reinforced Cement Mortar(2021-04) Kane, Seth; Thane, Abby; Espinal, Michael; Lunday, Kendra; Armagan, Hakan; Phillips, Adrienne J.; Heveran, Chelsea M.; Ryan, Cecily A.The development of methods to reuse large volumes of plastic waste is essential to curb the environmental impact of plastic pollution. Plastic-reinforced cementitious materials (PRCs), such as plastic-reinforced mortar (PRM), may be potential avenues to productively use large quantities of low-value plastic waste. However, poor bonding between the plastic and cement matrix reduces the strength of PRCs, limiting its viable applications. In this study, calcium carbonate biomineralization techniques were applied to coat plastic waste and improved the compressive strength of PRM. Two biomineralization treatments were examined: enzymatically induced calcium carbonate precipitation (EICP) and microbially induced calcium carbonate precipitation (MICP). MICP treatment of polyethylene terephthalate (PET) resulted in PRMs with compressive strengths similar to that of plastic-free mortar and higher than the compressive strengths of PRMs with untreated or EICP-treated PET. Based on the results of this study, MICP was used to treat hard-to-recycle types 3–7 plastic waste. No plastics investigated in this study inhibited the MICP process. PRM samples with 5% MICP-treated polyvinyl chloride (PVC) and mixed type 3–7 plastic had compressive strengths similar to plastic-free mortar. These results indicate that MICP treatment can improve PRM strength and that MICP-treated PRM shows promise as a method to reuse plastic waste.