Mechanical & Industrial Engineering
Permanent URI for this communityhttps://scholarworks.montana.edu/handle/1/33
The mission of the Mechanical & Industrial Engineering Department is to serve the State of Montana, the region, and the nation by providing outstanding leadership and contributions in knowledge discovery, student learning, innovation and entrepreneurship, and service to community and profession.
Browse
5 results
Search Results
Item Characterization of velocity fluctuations and the transition from transient to steady state shear banding with and without pre-shear in a wormlike micelle solution under shear startup by Rheo-NMR(2020-04) Al-kaby, Rehab N.; Codd, Sarah L.; Seymour, Joseph D.; Brown, Jennifer R.Rheo-NMR velocimetry was used to study shear banding of a 6 wt.% cetylpyridinium chloride (CPCl) worm-like micelle solution under shear startup conditions with and without pre-shear. 1D velocity profiles across the fluid gap of a concentric cylinder Couette shear cell were measured every 1 s following shear startup for four different applied shear rates within the stress plateau. Fitting of the velocity profiles allowed calculation of the shear banding characteristics (shear rates in the high and low shear band, the interface position and apparent slip at the inner rotating wall) as the flow transitioned from transient to steady state regimes. Characteristic timescales to reach steady state were obtained and found to be similar for all shear banding characteristics. Timescales decreased with increasing applied shear rate. Large temporal fluctuations with time were also observed and Fourier transform of the time and velocity autocorrelation functions quantified the fluctuation frequencies. Frequencies corresponded to the elastically driven hydrodynamic instabilities, i.e. vortices, that are known to occur in the unstable high shear band and were dependent upon both applied shear rate and the pre-shear protocol.Item Glass Dynamics and Domain Size in a Solvent-Polymer Weak Gel Measured by Multidimensional Magnetic Resonance Relaxometry and Diffusometry(2019-02) Williamson, Nathan H.; Dower, April M.; Codd, Sarah L.; Broadbent, Amber L.; Gross, Dieter; Seymour, Joseph D.Nuclear magnetic resonance measurements of rotational and translational molecular dynamics are applied to characterize the nanoscale dynamic heterogeneity of a physically cross-linked solvent-polymer system above and below the glass transition temperature. Measured rotational dynamics identify domains associated with regions of solidlike and liquidlike dynamics. Translational dynamics provide quantitative length and timescales of nanoscale heterogeneity due to polymer network cross-link density. Mean squared displacement measurements of the solvent provide microrheological characterization of the system and indicate glasslike caging dynamics both above and below the glass transition temperature.Item Quantifying NMR relaxation correlation and exchange in articular cartilage with time domain analysis(2018-02) Mailhiot, Sarah E.; Zong, Fangrong; Maneval, James E.; June, Ronald K.; Galvosas, Petrik; Seymour, Joseph D.Measured nuclear magnetic resonance (NMR) transverse relaxation data in articular cartilage has been shown to be multi-exponential and correlated to the health of the tissue. The observed relaxation rates are dependent on experimental parameters such as solvent, data acquisition methods, data analysis methods, and alignment to the magnetic field. In this study, we show that diffusive exchange occurs in porcine articular cartilage and impacts the observed relaxation rates in T1-T2 correlation experiments. By using time domain analysis of T2-T2 exchange spectroscopy, the diffusive exchange time can be quantified by measurements that use a single mixing time. Measured characteristic times for exchange are commensurate with T1 in this material and so impacts the observed T1 behavior. The approach used here allows for reliable quantification of NMR relaxation behavior in cartilage in the presence of diffusive fluid exchange between two environments.Item Combining Targeted Metabolomic Data with a Model of Glucose Metabolism: Toward Progress in Chondrocyte Mechanotransduction(2016-01) Salinas, Daniel; Minor, Cody A.; Carlson, Ross P.; McCutchen, Carley N.; Mumey, Brendan M.; June, Ronald K.Osteoarthritis is a debilitating disease likely involving altered metabolism of the chondrocytes in articular cartilage. Chondrocytes can respond metabolically to mechanical loads via cellular mechanotransduction, and metabolic changes are significant because they produce the precursors to the tissue matrix necessary for cartilage health. However, a comprehensive understanding of how energy metabolism changes with loading remains elusive. To improve our understanding of chondrocyte mechanotransduction, we developed a computational model to calculate the rate of reactions (i.e. flux) across multiple components of central energy metabolism based on experimental data. We calculated average reaction flux profiles of central metabolism for SW1353 human chondrocytes subjected to dynamic compression for 30 minutes. The profiles were obtained solving a bounded variable linear least squares problem, representing the stoichiometry of human central energy metabolism. Compression synchronized chondrocyte energy metabolism. These data are consistent with dynamic compression inducing early time changes in central energy metabolism geared towards more active protein synthesis. Furthermore, this analysis demonstrates the utility of combining targeted metabolomic data with a computational model to enable rapid analysis of cellular energy utilization.Item Influence of silicon on high-temperature (600 degrees C) chlorosilane interactions with iron(2017-02) Aller, Josh; Swain, Nolan; Baber, Michael; Tatar, Greg; Jacobson, Nathan; Gannon, Paul E.High-temperature (>500 °C) chlorosilane gas streams are prevalent in the manufacture of polycrystalline silicon, the feedstock for silicon-based solar panels and electronics. This study investigated the influence of metallurgical grade silicon on the corrosion behavior of pure iron in these types of environments. The experiment included exposing pure iron samples at 600 °C to a silicon tetrachloride/hydrogen input gas mixture with and without embedding the samples in silicon. The samples in a packed bed of silicon had significantly higher mass gains compared to samples not in a packed bed. Comparison to diffusion studies suggest that the increase in mass gain of embedded samples is due to a higher silicon activity from the gas phase reaction with silicon. The experimental results were supported by chemical equilibrium calculations which showed that more-active trichlorosilane and dichlorosilane species are formed from silicon tetrachloride in silicon packed bed conditions.